Bunn G2 Wartungshandbuch PDF herunterladen (Seite 7)

7

PROBABLE CAUSE

3. Bag Sensor. (cont.)

4. Motor overload protector.

1. Off/On/Start Switch

2. Bag Sensor

3. Relay

TROUBLESHOOTING (cont.)

PROBLEM

Grinder will not start. (cont.)

Grinder will not shut off.

REMEDY

(B) Refer to Service - Bag Sensor

Switch for testing and adjustment

procedures. See page 9.

Remove the plug located on the

right side of the housing. Press the

red “Reset” button visible through

the opening. Listen carefully for a

“click”. This resets the motor protec-

tion circuit and may indicate that an

overload has been encountered by

the motor. (An overload can occur

when something other than coffee is

inserted into the hopper for grinding.

Refer to Service - Motor for disas-

sembly.) See page 10 for AC Motors

or see page 13 for DC Motors.

(A) Move the switch to the “OFF”

position.

(B) Refer to Service - Off/On/Start

Switch for testing procedures. See

page 16.

(A) Remove bag from under the

dispense chute.

(B) Refer to Service - Bag Sensor

Switch for testing procedures. See

page 9.

Refer to Service - Relay for testing

procedures. See page 18.

10191 011500

1 2 3 4 5 6 7 8 9 10 11 12 ... 20 21

Kommentare zu diesen Handbüchern

Keine Kommentare