Bunn BXB Gebrauchs- und Pflegehandbuch PDF herunterladen (Seite 10)

5. To clear vinegar out of brewer, pour a carafe of fresh, cold water through the

brewer. With brew funnel in place, position carafe on base plate, then close

the lid to allow the water to run through the brewer. After it has run through,

empty carafe and repeat the process approximately 8-10 times

6. Replace sprayhead and brew funnel. Pour additional carafes of fresh, cold

water into the brewer as needed until water has no vinegar smell or taste.

7. Place carafe on base plate and plug in the brewer. Allow the water in the tank

to reach brewing temperature before using (approximately 15 minutes).

THERMAL CARAFE CLEANING (BT & ST)

To disassemble the thermal carafe for cleaning, rotate the lid

counterclockwise to remove. Occasionally, the brew through

valve should be removed and cleaned. Lift at the edge and

pull up. Use a mild, non-abrasive detergent to wash the lid

thoroughly – paying particular attention to the passage where

the brew through valve is located. After rinsing, replace the

brew through valve into the carafe lid. Do not use a scrub pad or other abrasive

cleaning device to clean the carafe, as this will scratch the stainless steel surface.

To remove coffee stains from inside the thermal carafe, place a paper filter in the

brew funnel and pour 2 teaspoons of Cascade

powder dishwasher detergent into

the paper filter. Slide brew funnel onto the funnel guide and open brewer lid. Pour

one carafe of cold water into brewer. Position carafe on brewer base plate and

close lid. When brewing cycle stops, remove brew funnel and discard the filter and

detergent; rinse funnel thoroughly. Allow carafe to sit for 10-15 minutes. Using a

long handled, soft bristled brush, clean inside of carafe as well as the outer rim to

remove any coffee stains or debris. Occasionally scrub the carafe pour lip and the

area around it, including the lid, with a mild detergent and warm water. Use a soft

cloth and scrub hard. When finished, pour out solution into sink and thoroughly

rinse carafe and lid with clean water.

DRAINING YOUR BREWER

The water in your brewer should be emptied whenever the brewer is taken on a

trip, shipped, stored in an unheated location with a chance of freezing, or will not

be used for an extended period of time. To drain your brewer:

1. Unplug brewer. Remove the brew funnel and sprayhead and set them aside.

2. Cool brewer by pouring a full carafe of fresh, cold water into the top. Place

the carafe on the base plate and close the lid. When water has stopped

flowing from the brewer, empty the carafe. Repeat this process and set the

carafe aside.

3. Grasp the back of the brewer and carefully turn it upside down over a sink.

Most of the water in the tank will flow from the sprayhead tube opening. Some

water may flow from the area around the top lid. Continue tipping the brewer

until the flow stops.

4. Replace the sprayhead and funnel after the water has been drained.

CLEANING AND MAINTENANCE (cont.)

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 27 28

Kommentare zu diesen Handbüchern

Keine Kommentare

Bunn BXB Gebrauchs- und Pflegehandbuch Seite 10

Kommentare zu diesen Handbüchern