Bunn H5E Bedienungsanleitung PDF herunterladen (Seite 6)

Program lockout switch:

The switch must be in the “SET” position in order to

access the program modes.

1. Disconnect the dispenser from the power source.

2. Remove the 4-40 screws and the top cover.

3. Use a small screwdriver to move switch to set

position.

4. Install top cover, connect dispenser to power

source.

Manual Energy Saver Mode:

The energy save mode will allow the tank temperature

to drop down to 140°F (60°C).

1. Simultaneously press and release the (+) and (-)

to “manually” activate energy save mode.

2. The display will alternately ﬂash between 140

and the current temperature to indicate it is in

the energy save mode.

3. Repeat procedure to exit energy save mode.

Programming the dispenser:

1. Press and hold upper hidden button (bottom

center of “BUNN” logo) until “P1” is displayed.

Adjusting temperature:

The switch must be in the “SET” position in order to

access the program modes.

1. Press and hold “TEMP” button until display

ﬂashes.

2. While display is ﬂashing, press and release the

(+) to increase or (-) to decrease temperature.

NOTE: If unit is “E” model, temp will stop at 205°F

(96°C). If unit is “X” model, temp display will jump

from 205°F (96°C) to 212°F (100°C).

Step forward

Step backward

Continued

PROGRAMMING

SET

LOCK

44306 022111

1 2 3 4 5 6 7 8 9

Keine Kommentare

Bunn H5E Bedienungsanleitung Seite 6