Bunn CDS-3 Bedienungsanleitung PDF herunterladen (Seite 7)

7

9. Align the auger shaft with the

flat fin of the auger. Push the

augers as far as they will go and

rotate them so the flat fins are

pointing up.

10. Thoroughly rinse the hoppers

and install them over the cool-

ing drums with augers. Slide

them into place and push them

down as far as they will go.

As much as possible, keep lu-

bricant from the inside of the

hoppers. The cleaner you keep

the food zone, the cleaner the

product you’ll serve the cus-

tomer.

11. Set the lids on the hoppers.

Slide front-to-back or lift off for

filling.

12. Plug in the hopper lid lamp

cables.

13. (CDS-2 only) Assemble the drip

tray.

14. (CDS-3 only) Loosen the two

front legs by turning counter-

clockwise to gain approxi-

mately .25" clearance. Install

the slots of the support bracket

over threaded studs of the legs

as shown in illustration. Tighten

the legs by turning clockwise to

secure the bracket in place.

APPROXIMATELY .25"

15. (CDS-3 only) Install the drip

tray.

INITIAL SETUP (CONT.)

27646 022500

1 2 3 4 5 6 7 8 9 10 11 12 ... 59 60

Kommentare zu diesen Handbüchern

Keine Kommentare