Bunn TB6Q Wartungshandbuch

TB3/TB6 SeriesIncluding: TB3; TB3-LP; TB3Q; TB3Q-LP; TB6; TB6QSTARTING WITH SERIAL NUMBER: TU00020000INSTALLATION & OPERATING MANUALBUNN-O-MATIC C

Page 10OPERATING CONTROLSA. ON/OFF SwitchON - Placing the switch in the left position allows the start switch to activate a timed brew cycle for thre

Page 1141465.1 042009CLEANINGCAUTION - CLEAN AND SANITIZE YOUR ICED TEA BREWER DAILYDAILY:1. Remove, disassemble and thoroughly clean and sanitize t

Page 241465.1 080112BUNN-O-MATIC COMMERCIAL PRODUCT WARRANTYBunn-O-Matic Corp. (“BUNN”) warrants equipment manufactured by it as follows:1) Airpots,

Page 3#00831.0000#00656.0001#03408.0000#03409.0000#37881.0000• FILL WATER TANK BEFORE ENERGIZING • DO NOT OVERLOAD CIRCUIT • KEEP AWAY FROM

Page 4ELECTRICAL REQUIREMENTSCAUTION - The brewer must be disconnected from the power source until specified in Initial Set-Up.120V model brewers requi

Page 5120V MODELSThese brewers must be connected to a cold water system with a minimum 1.0 gpm flow rate, and operating pressure between 20 and 90 psi

Page 6INITIAL SET-UP (TB3Q/TB3Q-LP/TB6Q ONLY)CAUTION - The brewer must be disconnected from the power source throughout the Initial Set-Up, except whe

Page 7INITIAL SET-UP (TB3/TB3-LP/TB6 ONLY)CAUTION - The brewer must be disconnected from the power source throughout the initial set-up, except when s

Page 8AUTO SWEETENER SET-UPCAUTION - The brewer must be disconnected from the power source throughout the Initial Set-Up, except when specified in the

Page 9ADJUSTING BREW VOLUMESNOTE: Check that the brewer is connected to water supply, the tank is properly filled, and a funnel and server are in place