Bunn TB6Q Wartungshandbuch PDF herunterladen (Seite 10)

Page 10

OPERATING CONTROLS

A. ON/OFF Switch

ON - Placing the switch in the left position allows the start switch to activate a timed brew cycle for three gallons

of tea.

OFF - Placing the switch in the right position stops the brew cycle. Stopping a brew cycle after it has been started

will not stop the ﬂow of water into the funnel until the tank siphons down to its proper level. The switch should

always be placed in this position after a brew cycle and whenever the brewer is unattended.

B. UNSWEET/OFF/SWEET Selector Switch (Models with Sweetener Only)

UNSWEET - Placing the switch in the left positional allows the start switch to activate a timed brew cycle for

three gallons of tea without sweetener.

OFF - Placing the switch in the middle position stops the brew cycle. Stopping a brew cycle after it has been

started will not stop the ﬂow of water into the funnel until the tank siphons down to its proper level. The switch

should always be placed in this position after a brew cycle and whenever the brewer is unattended.

SWEET - Placing the switch in the right position allows the start switch to activate a timed brew cycle for three

gallons of tea with sweetener.

C. LEFT/OFF/RIGHT Selector Switch (TB6/TB6Q Models Only)

LEFT - Placing the switch in the left position allows the start switch to activate a timed brew cycle for three gal-

lons of tea for the left side dispenser.

OFF - Placing the switch in the middle position stops the brew cycle. Stopping a brew cycle after it has been

started will not stop the ﬂow of water into the funnel until the tank siphons down to its proper level. The switch

should always be placed in this position after a brew cycle and whenever the brewer is unattended.

RIGHT - Placing the switch in the right position allows the start switch to activate a timed brew cycle for three

gallons of tea for the right side dispenser.

CAUTION - Make sure the switch, funnel and dispenser are in the correct positions before starting brew cycle.

D. Start Switch

Starts a brew cycle when the ON/OFF switch is in the "ON" position.

TEA BREWING

1. Begin each brew cycle with a clean empty brew funnel and server. (Be sure the server lid doesn’t interfere

with the ﬂow of dilution water.)

2. Insert a BUNN® ﬁlter into the funnel.

3. Pour the packet of loose fresh tea leaves into the ﬁlter. Approximately three to ﬁve ounces is recommended

for three gallons of beverage.

4. Level the bed of tea leaves by gently shaking.

5. Slide the funnel into the funnel rails until it stops. On TB6/TB6Q models, rotate the funnel handle left or right

to align the funnel discharge over the reservoir.

6. Place the ON/OFF switch in the “ON” position. (For brewers with a sweetener, place the UNSWEET/OFF/

SWEET switch in the "SWEET" or "UNSWEET" position)(LEFT or RIGHT on TB6/TB6Q)

7. Momentarily press the START switch.

8. After brew cycle has ﬁnished and tea no longer drips from the funnel tip, carefully remove the brew funnel

and discard the used ﬁlter.

CAUTION - The funnel contains hot liquids. Remove funnel slowly.

9. Place the ON/OFF (UNSWEET/OFF/SWEET) (LEFT/OFF/RIGHT )switch in the "OFF" position to prevent a false

start.

10. Fresh tea is available at the server faucet.

41465.1 042009

1 2 ... 5 6 7 8 9 10 11

Kommentare zu diesen Handbüchern

Keine Kommentare

Bunn TB6Q Wartungshandbuch Seite 10

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Kaffeemacher Bunn TB6Q