Bunn SINGLE TF DBC Bedienerhandbuch PDF herunterladen (Seite 24)

Page 24

PROGRAMMING FUNCTIONS - LEVEL 2 (cont.)

Setting Pulse Brew - ENTER TIMES:

NOTE: No water should flow from the brewer during

this set-up process.

1. This display should read 1ST ON TIME X:XX.

Choose the batch size to be set by pressing the

pad next to the indicator light. The batch size indi-

cator selected will be flashing.

2. Adjust the 1ST ON TIME using (-) and (+). When

finished, press DONE. (a)

3. The display will now read OFF TIME X:XX. Adjust

the OFF TIME using (-) and (+). When finished,

press DONE.(b)

4. The display will now read LAST ON TIME X:XX.

Adjust the LAST ON TIME using (-) and (+). When

finished, press DONE.(c)

5. The display will show the three times just entered

for that batch size. After a 5 second delay, the dis-

play will read 3 BATCHES DONE?(d and e)

P2411

6. If other batch sizes need to be modified, press

NO. The display will then read SET BY EXAMPLE.

7. In that screen, press NO. The display should now

read ENTER TIMES.

8. Press YES in this screen, then press a different

batch size pad and repeat steps 2 through 4. Re-

peat until all the desired batch sizes are set for the

left side.

9. When finished press YES in 3 BATCHES DONE?.

The display will then read SET PREINFUSION.

Another alternative is to press and release the

pad located on the front panel of the brewer to

exit SET PULSE BREW and return to the MAIN

SCREEN.

NOTE: Pressing ® before reaching the final setting

screen exits the setup and retains the old values.

35879 082203

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 48 49

Keine Kommentare

Bunn SINGLE TF DBC Bedienerhandbuch Seite 24